INSTALLATION INSTRUCTIONS TOYOTA RAV4 (1996-2000) PART NUMBER: TY-73-97 ...

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break. Pro.Fit logo and part number will be right side up and readable when installed. TOOLS REQUIRED: #1 Phillips screwdriver PARTS INCLUDED: Pro.Fit VSMTM and Instructions. LOCATION: Right of the radio STEP 1. Begin by removing radio trim bezel which is a separate piece surrounding radio. To do this, locate and remove two (2) Phillips screws located directly under radio. Grasp top portion of bezel, pulling down and out. This will release two (2) tabs. Set bezel aside. STEP 2. Remove screw to the right of the radio, directly above the centering pin. STEP 3. Attach hang-up cup onto the Pro.Fit VSMTM. Install Pro.Fit VSMTM, aligning it over the screw hole to the right of the radio and the centering pin. Insert and tighten screw. Reattach radio trim bezel. This completes the installation of your Pro.Fit VSMTM. Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal of this Pro.Fit VSMTM. Pro.Fit may not be held liable for any

INSTALLATION INSTRUCTIONS TOYOTA RAV4 (1996-2000) PART NUMBER: TY-73-97 ...

Category: Toyota
Source: www.pro-fit-intl.com
Download: 0 | Filesize:

Download PDFboom bookmark and share

Related Post